Decawave DWM1001

Support for the Decawave DWM1001 development board. More...

Detailed Description

Support for the Decawave DWM1001 development board.

Overview

The Devawave DWM1001 development board includes a DWM1001 module which is based on a Nordic nRF51832 microcontroller. This microcontroller is an ARM Cortex-M4 with 64KB of RAM and 512KB of flash memory. It also provides in integrated BLE radio. The DWM1001 module also contains an UWB transceiver connected to the microcontroller via SPI (not supported yet).

Flash the board

This board can be flashed using OpenOCD or JLink. Jlink is the default programmer. To program this board, plug it to your computer via USB and run the following command:

make BOARD=dwm1001 -C examples/hello-world flash

To program the board with OpenOCD, use:

PROGRAMMER=openocd make BOARD=dwm1001 -C examples/hello-world flash

Accessing STDIO via UART

The STDIO is directly accessible via the USB port. On a Linux host, it's generally mapped to /dev/ttyACM0.

Use the term target to connect to the board serial port

make BOARD=dwm1001 -C examples/hello-world term

Files
file	board.h
	Board specific configuration for the DWM1001 dev board.
file	gpio_params.h
	Configuration of SAUL mapped GPIO pins.
file	periph_conf.h
	Peripheral configuration for the DWM1001 dev board.