Support for the Nordic nRF51 Dongle. More...
Detailed Description
Support for the Nordic nRF51 Dongle.
Overview:
The nRF51822 is a multi-protocol SoC ideally suited for Bluetooth® low energy and 2.4GHz ultra low-power wireless applications from Nordic Semiconductor. The nRF51822 is built around a 32-bit ARM® Cortex™ M0 CPU with 256KiB flash + 16KiB RAM. The embedded 2.4GHz transceiver supports Bluetooth low energy as well as 2.4GHz operation.
Nordic's development kit contains two different boards:
- pca10000: a USB-dongle containing the nRF51822 and a RGB-Led
- pca10005: two a basic nRF51822 boards making the MCU pins available
While the pca10000 contains an on-board J-Link debugger, the pca10005 boards have to be flashed/debugged using the (included) external J-Link device.
Hardware:
| MCU | NRF51822QFAA |
|---|---|
| Family | ARM Cortex-M0 |
| Vendor | Nordic Semiconductor |
| RAM | 16KiB |
| Flash | 256KiB |
| Frequency | 16MHz |
| FPU | no |
| Timers | 3 (2x 16-bit, 1x 32-bit [TIMER0]) |
| ADCs | 1x 10-bit (8 channels) |
| UARTs | 1 |
| SPIs | 2 |
| I2Cs | 2 |
| Radio | 2.4GHz BLE compatiple, +4dBm to -20 dBm output, -93 dBm RX sensitivity |
| Vcc | 1.8V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
Flashing the Device:
The nRF51822 PC10000 board is shipped with an on-board JLink debugger. However the PC10004/5 board uses an external flash tool as seen in the Image above. Under Linux, the easiest way flashing the nRF51822 is using the JLink tool(version >4.85) from Segger.
To interact with the board just start the tool using the following command: # JLinkExe -device nrf51822
For RIOT itself there is a Flash-Script available. When using any of the Examples type in the following command: # Make -B clean flash
Files | |
| file | board.h |
| Board specific configuration for the nRF51 Dongle. | |
| file | periph_conf.h |
| Peripheral configuration for the Nordic nRF51 Dongle. | |
