Loading...
Searching...
No Matches
gpio_params.h
Go to the documentation of this file.
1/*
2 * Copyright (C) 2018 Eistec AB
3 *
4 * This file is subject to the terms and conditions of the GNU Lesser
5 * General Public License v2.1. See the file LICENSE in the top level
6 * directory for more details.
7 */
8
19#ifndef GPIO_PARAMS_H
20#define GPIO_PARAMS_H
21
22#include "board.h"
23#include "saul/periph.h"
24
25#ifdef __cplusplus
26extern "C" {
27#endif
28
33{
34 /* There are three LEDs on board, but only two are software controllable,
35 * and one is driven by the debugger interface unless hardware mods have
36 * been applied. See boards/usb-kw41z/include/board.h */
37#ifdef LED0_PIN
38 {
39 .name = "D2",
40 .pin = LED0_PIN,
41 .mode = GPIO_OUT,
43 },
44#endif /* LED0_PIN */
45#ifdef LED1_PIN
46 {
47 .name = "D3",
48 .pin = LED1_PIN,
49 .mode = GPIO_OUT,
51 },
52#endif /* LED1_PIN */
53 {
54 .name = "SW1",
55 .pin = BTN0_PIN,
56 .mode = BTN0_MODE,
57 .flags = (SAUL_GPIO_INVERTED),
58 },
59};
60
61#ifdef __cplusplus
62}
63#endif
64
65#endif /* GPIO_PARAMS_H */
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition gpio_params.h:33
#define LED1_PIN
TX LED yellow.
Definition board.h:35
@ GPIO_OUT
select GPIO MASK as output
Definition periph_cpu.h:165
Parameter definitions for mapping peripherals directly to SAUL.
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition periph.h:44
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition periph.h:43
Direct mapped GPIO configuration values.
Definition periph.h:51
const char * name
name of the device connected to this pin
Definition periph.h:52
Board specific definitions for the Zigduino board.