Loading...
Searching...
No Matches
board_common.h File Reference

Board specific definitions for the iotlab-m3 board. More...

Detailed Description

#include <stdint.h>
#include "cpu.h"
#include "periph_conf.h"
#include "periph_conf_common.h"
#include "stm32_leds.h"
+ Include dependency graph for board_common.h:

Go to the source code of this file.

Set the default baudrate to 500K for this board

#define STDIO_UART_BAUDRATE   (500000U)
 

Xtimer configuration

Tell the xtimer that we use a 16-bit peripheral timer

#define XTIMER_WIDTH   (16U)
 

ztimer configuration

#define CONFIG_ZTIMER_USEC_TYPE   ZTIMER_TYPE_PERIPH_TIMER
 
#define CONFIG_ZTIMER_USEC_DEV   TIMER_DEV(0)
 
#define CONFIG_ZTIMER_USEC_MIN   (2)
 

Define the interface to the AT86RF231 radio

{spi bus, spi speed, cs pin, int pin, reset pin, sleep pin}

#define AT86RF2XX_PARAM_CS   GPIO_PIN(PORT_A, 4)
 
#define AT86RF2XX_PARAM_INT   GPIO_PIN(PORT_C, 4)
 
#define AT86RF2XX_PARAM_SLEEP   GPIO_PIN(PORT_A, 2)
 
#define AT86RF2XX_PARAM_RESET   GPIO_PIN(PORT_C, 1)
 

LED pin definitions and handlers

#define LED0_PIN_NUM   2
 
#define LED0_PORT   GPIO_PORT_D
 GPIO port of LED 0.
 
#define LED0_PORT_NUM   PORT_D
 
#define LED1_PIN_NUM   5
 
#define LED1_PORT   GPIO_PORT_B
 GPIO port of LED 1.
 
#define LED1_PORT_NUM   PORT_B
 
#define LED2_PIN_NUM   10
 
#define LED2_PORT   GPIO_PORT_C
 GPIO port of LED 2.
 
#define LED2_PORT_NUM   PORT_C